Sewage Ejector Pump Installation, Repair & Replacement in Denver, CO
Enter your contact details here
Professional Sewage Ejector Pump Services in Denver
Professional Plumbers Denver provides sewage ejector pump installation, repair, replacement and maintenance for residential and commercial properties in Denver, CO. If your basement bathroom or other below-grade plumbing needs a wastewater pumping system, our team can assess the system and recommend an appropriate solution.
Sewage ejector pump installation
We install pumps and basins for basement bathrooms, laundry areas and other fixtures that sit below the sewer line, choosing equipment that fits the fixtures and the building.
Sewage ejector pump repair
We diagnose pumps that will not start, run constantly, make unusual noise or fail to empty the basin, and repair or replace the failing parts.
Ejector pump replacement
When a pump is worn out, undersized or failing repeatedly, we replace it and the related components that need replacing.
Preventive maintenance and inspection
We inspect the pump, basin, controls, check valve and discharge piping so small problems are found before they become backups.
What Is a Sewage Ejector Pump?
A sewage ejector pump moves wastewater, including toilet waste, from fixtures that are below the level of the sewer line up to the building's drain line. It is used in basements and other lower levels where gravity cannot carry wastewater out. Wastewater from the connected fixtures collects in a sealed basin, and the pump lifts it to an approved drainage connection. A sewage ejector pump is not a flood-prevention device. It deals with wastewater from your fixtures and does not stop stormwater or groundwater from entering a basement.
How Does a Sewage Ejector Pump Work?
Collection basin
Fixtures in the lower level drain into a basin that holds the wastewater. The basin is sealed and vented, so odors and sewer gas do not enter the room.
Pump and discharge piping
When the water in the basin reaches a set level, the pump turns on and pushes the wastewater up and out through discharge piping to the building drain.
Check valve and venting
A check valve in the discharge line keeps pumped wastewater from flowing back into the basin. A vent lets air move through the system so the pump and the drains work properly.
Float switch and alarm
A float switch senses the water level and starts and stops the pump. Many systems also have an alarm that warns you when the level is too high or the pump has failed.
Signs Your Sewage Ejector Pump Needs Repair
Sewage odors near the basin
A smell of sewage near the basin or lower-level fixtures can mean a problem with the seal, the vent or the pump.
Unusual noises or excessive vibration
Grinding, humming without pumping or rattling suggest a failing motor, a jam or worn parts.
Pump running continuously
A pump that never shuts off, or that cycles on and off rapidly, may have a stuck float switch, a faulty check valve or another problem.
Slow drainage or sewage backup
Slow drains or sewage backing up from basement fixtures can mean the pump is not emptying the basin.
Pump fails to activate
If the basin fills and the pump does not start, the cause may be the float, the power supply or the pump itself. Do not open the basin or reset electrical parts yourself.
Common Sewage Ejector Pump Problems
| Problem | Possible cause | What a plumber checks |
|---|---|---|
| Pump will not start | Power or breaker problem, stuck float switch, failed motor | Controls, float, power supply, pump |
| Pump runs constantly | Stuck float, failed or missing check valve, jammed pump | Float, check valve, discharge line |
| Pump cycles on and off rapidly | Check valve letting water flow back, float problem | Check valve, float position |
| Weak or no pumping | Clog, worn impeller, blocked discharge line | Pump, discharge piping |
| Odors in the room | Unsealed or damaged basin lid, vent problem | Basin seal, vent |
| Alarm sounding | High water level, pump failure | Pump, float, power |
What to Do When a Sewage Ejector Pump Stops Working
- Stop using the fixtures connected to the basin: toilets, sinks, showers and the washing machine.
- Keep people and pets away from any sewage overflow.
- Do not open the basin or touch electrical equipment in a wet area. Sewage can carry harmful microorganisms, and standing water near electrical parts is dangerous.
- If sewage has overflowed, avoid contact with it and arrange appropriate cleanup.
- Do not keep resetting a tripped breaker or try to run the pump by hand. A repeated trip means something is wrong, and the cause should be found first.
- Call a plumber to inspect the pump, float switch, check valve, discharge piping and alarm.
Pump failure or sewage backup? Call (720) 390-2652.
Sewage Ejector Pump vs. Sump Pump
| Factor | Sewage ejector pump | Sump pump |
|---|---|---|
| Main purpose | Moves wastewater from below-grade plumbing fixtures | Removes groundwater collected in a sump pit |
| Typical location | Sealed basin in a basement | Sump pit in a basement or crawl space |
| What it handles | Wastewater, with solids within the pump's rated capability | Mostly groundwater |
| Typical use | Basement toilet, shower, sink or laundry drainage | Groundwater control |
| Discharge | Approved drainage connection | Approved discharge location |
Do not use a standard sump pump for sewage or toilet waste. The pump must match the wastewater, the solids it must handle, the basin design and the manufacturer's instructions. See our sump pump services page.
Our Sewage Ejector Pump Installation and Repair Process
- Assessment. We look at the fixtures, the basin, the pump, the controls, the check valve and the discharge piping.
- Recommendation and estimate. We explain the repair or replacement options and give you an estimate before work begins.
- Repair or installation. We repair or replace the pump and related parts, or install a new basin, pump, check valve and discharge line.
- Venting and electrical. The system needs proper venting and a suitable power supply. Electrical work should be done by a qualified electrician and meet code.
- Testing. We run the system, check the float and the alarm, and look for leaks.
- Walkthrough. We explain how the system works and what to watch for.
Residential and Commercial Ejector Pump Services
Homes with basement bathrooms, laundry rooms and wet bars often need a sewage ejector pump. Commercial buildings, including offices, restaurants and multi-tenant properties, can have lower-level restrooms and fixtures that also need one. Commercial systems can be larger and may have extra requirements, so we plan them with your property's needs in mind. See our commercial plumbers in Denver page.
Sewage Ejector Pump Maintenance
A pump works hard in a sealed, wet environment. Regular inspection helps catch a stuck float, a failing check valve, a worn motor or a clog before they cause a backup. How often a system should be inspected depends on the equipment, how much it is used and the manufacturer's guidance, so ask us for a schedule that fits yours. Only toilet paper and human waste should go down fixtures connected to an ejector pump. Wipes, grease, feminine products and other trash can jam the pump.
How Much Does Sewage Ejector Pump Repair or Replacement Cost in Denver?
Cost depends on the problem, the pump and basin you have, how easy the system is to reach, whether the check valve, float or discharge piping must be replaced, electrical needs and permit requirements. A float switch repair is a different job from a new pump and basin. We provide a free on-site assessment and an estimate before work begins. Service life varies with pump quality, use, installation and maintenance, so there is no single lifespan to count on.
Denver Permits and Code Considerations
Sewage ejector installation can involve plumbing, venting and electrical work, and permits and inspections may apply. Some non-residential buildings have extra requirements under Denver's adopted codes, such as backup pumps and alarms, and work that touches the building sewer or public sewer can have its own permit steps. Requirements depend on the type of building and the work, so confirm with Denver Community Planning and Development, or ask your plumber what applies to your property.
Why Choose Professional Plumbers Denver?
- Licensed and insured plumbers for residential and commercial properties.
- Free on-site assessment and estimates before work begins.
- Serving Denver since 2005.
- Open 24/7 for plumbing emergencies, including sewage backups.
- Clear explanations of what failed and what your options are.
- Local office at 4400 S Quebec St, Suite 208, Denver, CO 80237.
Sewage Ejector Pump Services in Denver and Nearby Areas
Basements and lower levels are common in Denver homes, and many need a pump where gravity drainage cannot reach the sewer connection. We serve Denver and nearby communities, including Aurora, Lakewood, Littleton, Arvada, Centennial, Englewood, Highlands Ranch, Castle Rock and Greenwood Village. See all service areas.
If you have repeated backups, our sewer repair and drain cleaning services can help find the cause.
Sewage Ejector Pump FAQs
What is a sewage ejector pump used for?
A sewage ejector pump moves wastewater, including toilet waste, from fixtures that sit below the sewer line, such as a basement bathroom or laundry, up to the building's drain line. It is used where gravity cannot carry the wastewater out.
How does a sewage ejector pump work?
Wastewater collects in a sealed, vented basin. When the level rises, a float switch turns the pump on, and the pump pushes the wastewater up through discharge piping. A check valve stops it from flowing back, and many systems have an alarm for a high water level or pump failure.
What is the difference between a sewage ejector pump and a sump pump?
A sewage ejector pump handles wastewater from plumbing fixtures, including solids within its rated capability, and sits in a sealed basin. A sump pump removes groundwater from a pit and is not designed for sewage or toilet waste. Using the wrong pump can cause failures and sewage problems.
What are the signs of a failing sewage ejector pump?
Common signs are sewage odors near the basin, unusual noises, a pump that runs constantly or will not start, slow drains, sewage backing up from basement fixtures and an alarm that sounds. If you notice these, stop using the connected fixtures and call a plumber.
Why does my sewage ejector pump keep running?
Possible causes include a stuck float switch, a failed check valve letting water flow back into the basin, a jam or clog, or a pump that is worn out. Do not open the basin or touch the electrical parts yourself. A plumber needs to find the cause.
How long does a sewage ejector pump usually last?
Service life varies with the pump's quality, how much it is used, how it was installed, what goes down the drains and how well it is maintained. There is no fixed lifespan, so have the system inspected and replace the pump when it starts to fail repeatedly.
How often should a sewage ejector pump be inspected?
There is no single interval for every system. Manufacturer guidance, the type of equipment and how much the system is used all matter, and commercial or heavily used systems often need more frequent checks. A plumber can recommend an inspection schedule for your system.
How much does sewage ejector pump replacement cost in Denver?
Cost depends on the pump and basin, how easy the system is to reach, whether the check valve, float or discharge piping must be replaced, electrical needs and permit requirements. We provide a free on-site assessment and an estimate before work begins.
Can a sewage ejector pump handle toilet waste?
Yes. A sewage ejector pump is designed to handle toilet waste and solids within its rated capability, which a standard sump pump is not. To avoid jams, only toilet paper and human waste should go down fixtures connected to the pump, never wipes, grease or trash.
Does Professional Plumbers Denver provide sewage ejector pump repair and installation?
Yes. We install, repair, replace and maintain sewage ejector pumps for residential and commercial properties in Denver and nearby communities. Call (720) 390-2652 to request an inspection or an estimate.
Request Sewage Ejector Pump Service in Denver
Contact Professional Plumbers Denver to request an ejector pump inspection or a service estimate. Call (720) 390-2652 or request service.
Professional Plumbers Denver, 4400 S Quebec St, Suite 208, Denver, CO 80237 | info@professional-plumbers-denver.com | Open 24 hours, 7 days a week



